#Behringer x32 setup diagram how to

If you are handy with a soldering iron, you can wire one up yourself! It is very similar to what I used with my Stereo to Mono Conversion Article. This noise can be reduced and even completely removed by the use of an isolation transformer. You will sometimes notice that if you connect a PC/Computer to your board with a direct cable like the one suggested above, you will get noise. Or if you have a case on your phone, Monoprice also has this cable which is more thin. Check out this cable from Monoprice which has yielded good results for me. A quality 1/8th inch stereo to stereo RCA (or 1/4 inch) will quickly be able to connect the device to your Aux 5&6 using the RCA inputs on the back of the board. Really any 1/8th inch stereo jack, these are probably the easiest to connect.

With that being said, typically when playing something from a PC, iPhone, or CD, the signal is going to be polished enough to the point where we would not need to apply compression, so in order to save my XLR inputs and main channels, I would rather connect these devices into the Auxes. Another main difference between them is that the Auxes have limited processing to where only the EQ section is able to be applied to the signal. The main difference between the two is that natively the main channels are connected to the XLR inputs and the Auxes are connected to the 1/4 inch TRS inputs. We have two avenues with the Behringer X32 and Midas M32 for channels to be presented to our main bus, we have the main Channels (1-32) and the Auxes (Aux 1-6). Today I am going to go through a few of my thoughts when regarding devices like these. From PCвЂ™s, iPhones, or CD players, all of them have different connections and require a bit of creative thinking to get them connected to your console. If anyone is able to provide a step by step approach to this that would be amazing.I have gotten a lot of questions in the past regarding connecting external devices to the Behringer X32. I found this diagram online and I think it accurately depicts what I am trying to do but I am struggling to connect the dots on the machine itself. To have all audio from my computer over USB sent to analog channels 7/8 on the X-32 as I am running those to a separate mixer that runs sound to the monitors.

In an attempt to be concrete let me specify my goal:

#Behringer x32 setup diagram how to

I am effectively asking how to do this on the X32. I only know how to describe it as sending USB input to the 'Main mix' - this is because I have a Behringer X-22 USB and a little Behringer XENYX Q502 USB and both of those mixers have little buttons on them that say 'USB TO MAIN MIX' that takes whatever is sent to the mixer from the computer and routes it back out to the mixer's main analog L/R outs. Or I did, and just didn't understand it as I am new to this level of mixing. While this is clearly because of i/o routing I have yet to find an answer from the internet that broke down what I was trying to do. However, on input monitoring or playback I get no sound out of the x32. When I create a track and set it to one of the digital inputs I get levels. In my DAW I see all 32 inputs and outputs. I'm using an x32 rack unit in my home studio as a usb audio interface.